Usl JSD-100 Instalační manuál stáhnout pdf (Strana 10)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 9 of 42

Figure 10 Inserting the IMB into the projector

Insert the IMB as shown in Figure 10.

The IMB should slide into the projector on the rails provided by the IMB slot, and the IMB

faceplate should be flush with the other existing faceplates once properly inserted.

2.5.2 Connecting the IMB to the SX-2000 server

The IMB on the projector and the SX-2000 server must be connected for proper operation.

There are two cables to be connected between the projector and the SX-2000 server:

• CAT-5E network cable to connect the network between the projector and the server.

The projector and server can also be connected through a network switch.

• PCI-e cable for connecting the IMB installed on the projector and to PCI-e slot on the

server back panel.

The PCI-e cable has a square metal connector and a green circular plastic tab located on each

end. The green tab is used to release the PCI-e connection. To insert the PCI-e cable into the IMB

or server, push the PCI-e cable connector firmly into the respective to the PCI-e slot. To release

this cable from the PCI-e slot on the server or IMB, pull on the green tab until the cable is

removed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Žádné komentáře

Usl JSD-100 Instalační manuál Strana 10