Usl JSD-100 Instalační manuál stáhnout pdf (Strana 28)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 27 of 42

3.2 Audio Setup

Not every case will require a Digital-to-Analog Converter (DAC) as some sound processors are

able to receive digital input. In the case that a DAC is required the first thing that should be

done is to connect the server to the DAC. This device converts the digital audio signal to an

analog audio signal. The DAC is then connected to a sound processor that processes the analog

audio signal and outputs it to the amplifier, and subsequently the cinema’s speakers.

The following sections document the installation instructions for the server with some of the

popular DACs and sound processors.

3.2.1 USL ECI-60

Since the USL ECI-60 has a digital input channel, the audio output of the server can be

connected directly to the ECI-60 using a 25-pin D-Sub cable.

1. Connect one end of the 25-pin D-Sub audio cable to the audio output on the server.

2. Connect the other end of the audio cable into the input labeled “AES 8 Ch Input” on the

USL ECI-60.

3.2.2 Yamaha DA824

There are several ways in which the Yahama DA824 can be configured with the server. The

simplest configuration is the straight through AES/EBU Connection. This again uses the 25-pin

D-Sub cable.

1. Connect one end of the 25 pin D-Sub audio cable to the audio output on the server.

2. Connect the other end of the audio cable into the input labeled “AES 8 Ch Input” on the

Yamaha DA824.

3.2.3 USL DAX-602

The USL DAX-602 has a direct AES-EBU Digital Input as well. The audio output of the server can

be connected directly using the 25-pin D-Sub cable.

1. Connect one end of the 25-pin D-Sub audio cable to the audio output on the server.

2. Connect the other end of the audio cable into the input labeled “AES-EBU Digital In” on

the USL DAX-602.

3.2.4 Dolby DMA8

The Dolby DMA8 has a direct input for AES digital input. The audio output of the server can be

connected directly using the 25 D-Sub Cable.

1. Connect one end of the 25 pin D-Sub audio cable to the audio output on the server.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

Žádné komentáře

Usl JSD-100 Instalační manuál Strana 28