Usl JSD-100 Instalační manuál stáhnout pdf (Strana 33)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 32 of 42

Figure 33 GPIO automation device settings

If the output pulse width is left blank, the default value of 50ms will be used. If a different

output pulse width is required, the value can be entered in the ‘Output Pulse Width’ setting.

Click the [Save] button to save any changes made.

3.3.5 Automation setup for projectors

The SX-2000 server supports automation for Barco, Christie and NEC projectors. Follow the steps

below to configure a projector device in the server automation interface.

1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this

case, it is “PROJECTOR”. Set the device type to “PROJECTOR” (see Figure 34).

2. Click [OK] and set up the device parameters for the projector device.

3. Enter the IP address of the projector device (see Figure 35).

4. Set the correct model of the projector. The port number will automatically change to

the default automation port number for the model. If the projector is a Series 2

projector, check the ‘Series 2’ checkbox.

5. Enter the ‘Login’ and ‘Password’ for the projector if required.

6. Click the [Save] button to save configured settings.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

Žádné komentáře

Usl JSD-100 Instalační manuál Strana 33